Thermal protection ballast heating test chamber LGHX-226
Designed and manufactured according to GB19510 Appendix D standard. EMI receiver product parameters: a. Box size: 610 × 610 × 610mmb. Sheet heat-resistant material thickness: 25 mmc. Test partition size: 560 × 560mmd. Test partition material: insulation asbestos e. 4 strip heater heating, each power is 300W The heating surface is 40×300mmf. Heating method: When the heating starts, the temperature rises rapidly, the power is large, and the heating power is smaller when the temperature is close to the set temperature. g. Temperature control mode: PID automatic temperature control. h. incubator temperature
Introduction:
Designed and manufactured according to GB19510 Appendix D standard.
Product parameters:
a. Box size: 610 × 610 × 610mm
b. Sheet heat resistant material thickness: 25 mm
c. Test partition size: 560 × 560mm
d. Test separator material: heat preservation asbestos
e. 4 strip heaters are heated, each power is 300W, and the heating surface is 40×300mm
f. Heating method: When the heating starts, the temperature rises rapidly and the power is large. When the temperature is close to the set temperature, the heating power is smaller.
g. Temperature control mode: PID automatic temperature control.
h. Adjusting range of oven temperature: RT+10°C—70°C
i. Test temperature: 40_5+0
j. Temperature uniformity in the incubator: ±3 ° C (35 ° C measurement)
k. Temperature fluctuation in the incubator: ±1 °C
l. Sample power supply: The electrical connection line enters the 150mm square opening as shown in Figure D.1.
m. Thermal protection ballast heating test chamber uses thermocouple to measure temperature.
Previous: Lamp adjustment device bending tester