Current measurement circuit overload test device
This instrument is designed and manufactured according to the requirements of the gb4793.1:16.1 standard, and is suitable for samples with a contact resistance not exceeding 0.1 ohms. The equipment is 10 times times the rated current of the sample for 1 seconds to check whether the sample is qualified. The device uses a 100A AC contactor to switch whether the current is applied. With AC voltmeter to show the voltage required for the test. Technical data: Charging pile test equipment • Working power: 220v±10%,50hz; Test Current range: 1-100 • Test time: 1 seconds; device internal resistance: 0.1 ohm
Brief introduction:
This instrument is based on
gb4793.1:16.1 standard design and manufacture of special test equipment, suitable for contact resistance of less than 0.1 ohm sample. The equipment is 10 times times the rated current of the sample for 1 seconds to check whether the sample is qualified. The device uses a 100A AC contactor to switch whether the current is applied. With AC voltmeter to show the voltage required for the test.
Technical parameter:
• Working power: 220v±10%,50hz;
• Test current range: 1-100 A;
• Test time: 1 seconds;
• Device internal resistance: 0.1 ohm;
Main accessories:
3kw Regulator 1 sets
3kw Transformer 1 sets
• Voltage Meter 1 Sets
• Schneider 100A AC CONTACTOR 1 sets
• Timer 1 set
Previous: Safety Test Profitest Mxtra